Micromot Drilling and Milling Machine 60/E

With a diameter of only 35mm and its low weight (230g) it offers convenient handling second to none in its class. The balanced motor effortlessly drives the ground ball bearing spindle allowing for a quiet run with a pleasant sound. High-quality MICROMOT steel collets ensure accurate clamping of even the smallest shafts, without rattling or vibrating of bits and cutters.

A mains adapter is required to operate the MICROMOT 60 devices. We recommend the PROXXON mains adapter W26 odr W27.

For milling, drilling, routing, de-scaling, polishing, cutting, cleaning, swing, engraving, etc. Useable on any workable material e.g. steel, precious metals, glass, ceramics, plastics, precious stones etc. High precision: ball bearing spindle. Special, balanced, low noise DC motor with high life expectancy. Variable electronic speed control with feedback effect (high engine power in the lower revolutions are). Housing of glass-fibre reinforced POLYAMIDE with soft component in the finger grip area. 20 mm collar for fitting MICROMOT accessories. Six MICROMOT collets (1.0 - 1.5 - 2.0 - 2.4 - 3.0 and 3.2 mm) are supplied.

Technical data:

Direct voltage: 12-18 V
Power consumption: 40W max.
Stroke speed: 5.000 - 20.000 rpm
Length: ca. 220 mm
Weight: ca. 230 g
With thyristor electronic speed control

Use of a transformer (W26 or W27) is required.

1.) The standard 20mm collar allows use in the drill stands MB 140/S and MB 200 as well as in the universal holder UHZ.
2.) Stable housing of glass-fibre reinforced POLYAMIDE. With a soft component in the finger grip area.

3.) Infinitely variable electronic speed control with feedback effect. For high engine power also at lower speeds.

Note:
The speed control of our 12 volt devices only works when operated via nonstabilised power supply units (e.g. all MICROMOT mains adapters). Connection to stabilised power supply units is possible. However, the devices will then operate with maximum rotational speeds (also applies to operation with batteries).